Introduction

　　The mechanical seal acts as a check valve and a slider bearing. The obvious function is that of a check valve to prevent liquid under pressure from leaking out of the pump, or from drawing air into the pump when under vacuum conditions.

　　Seal Life

　　Since the seal must function as a slider or friction bearing, the seal has an unpredictable life span. The seal of a centrifugal pump is usually replaced many times during the life of a pump. All bearing need lubricant and the seal lubricant is the liquid being pumped. Liquid infiltrates between the contact faces of the primary and mating rings. Some of this liquid does find its way through to the atmosphere but is so slight as to only be noticed as corrosion of 'build up' on the pump adapter. The condition of the pumped liquid will greatly affect seal life.

　　Abrasives

　　The number one enemy of a mechanical seal is abrasive particles in the liquid being pumped. Abrasives may be anything from dirt to dissolved impurities in the liquid precipitating out of solution. These abrasive particles infiltrate with the liquid between the seal faces and grind away the carbon primary ring. The normal shiny face of the primary ring and mating ring.

　　Heat Damage

　　Excessive heat can damage the seal in two areas - the primary ring and the elastomer parts. The primary ring is made primarily of carbon. Should the pump be operated without liquid - even for a very short period of time - the primary and mating ring faces are denied lubricant. This causes the faces to become very hot. The binder mixed with the carbon breaks down and the face of the primary ring turns to a dull black powder.

　　Conclusion

　　The forgoing is a brief discussion of some of the most common reason why seal life is shortened. Under normal conditions, seals wear out much faster than the other pump parts. Abrasives and excessive heat greatly shorten the seal's life span.